2.7Ax4 4-way Brushed ESC Mixed/Independent Mode for Loading/Unloading Tank 1:35

Description

Description:
Quantity:1pc
2.7Ax4 four-way four-way brushed ESC mixed control / independent mode loading and unloading tank 1：35
parameter:
Voltage 6v-10v (battery +-reverse connection to burn ESC, JST anti-reverse plug has been equipped, unless you force hard plug)
1-4 single long-distance running 2.7A peak 6A (previously 1.8A, peak 3.5A)
The midpoint of the remote controller is fixed at PWM 1500us (+50 -50). The run length is automatically adjusted from the lowest 800-1100 and the highest 1900-2200. If it exceeds 800-2200, it is considered an illegal signal and the ESC is locked.
Power-on prompt (you will hear a “beep” from the motor to prompt power-on)
Start with the neutral point (the throttle channel is about 1500, you will hear the motor beep, the ESC will start)
With out-of-control protection (lost signal (in the accident, the signal line was disconnected)), for safety and motor protection, you need to return the throttle to the center and unlock again.
The ESC has a certain overload and overheat protection (such as running above the rated current, the output of the overheated motor will stop, but if you suddenly connect a 5A motor, it will burn out)
Each group of motor wires is directly connected to the motor, do not confuse it, otherwise the ESC will be damaged
other:
Increased bec, output 5v, maximum 1.5A, when the current is large, the regulator chip 7805 has a lot of heat, pay attention to heat dissipation
Size: 30x27.5mm
There are two modes:
1 and 2 channel mixed control mode (factory default) (both throttle / steering mode): 2 or 3 channels (2 channels are recommended because 2 channels automatically return to center) to control the throttle, and 1 channel (or 4 channels) to control the speed difference steering The ratio of the throttle steering channel is 100%, and the throttle has priority. (Mixed control operation is convenient, so Henglong tank is also a mixed control mode)
4-way independent mode: 1, 2, 3, 4 channels are independently controlled, the motor output is 100% when the throttle is 100%. Equivalent to 4 independent ESCs.
(Requires 4-way independent mode, please disconnect the J1 solder joint on the back (scratch with an electric soldering iron))
Payment Policy :
We only accept payments via PayPal.
Shipping Time & Method:
Item will be shipped within 3 days after payment is confirmed.
Goods will be sent via airmail .
Delivery takes about 18-25 business day (without holidays).
All products have been checked and packaged in good condition before dispatch.
Please make sure your address in PayPal is matched with your shipping address before pay. If you would like to change the address, please contact us IMMEDIATELY after your payment.
Return policy :
After receiving item.,items can be returned within 30 days .
Items must be the original packaging.
No use. No damage.
Buyers bear the freight cost.